Machine in Action

If you have read my previous 2 posts you will now know how I make a design and how I send it to the embroidery machine. I will now show you the last stage of the process.

STEP 1 – You need to use a special backing material on every product you fasten to the machine. This stabilises the fabric and prevents distortion. You need to cut the right size backing for the size of the frame needed – see step 2.

STEP 2 – You then need to fit the garment into a frame to fasten it to the machine. (The frame size depends on the design size). You have to put the backing over the frame without the clips then put the garment on top of that then the other part of the frame fits inside and holds it altogether.

STEP 3 – You then clip the frame onto the machine.

STEP 4 – The machine is now ready to GO!!

THE FINISHED PRODUCT

I hope you have enjoyed reading the process to make a product. I hope I have explained it clearly enough! If you have any questions please don’t hesitate to ask. Thank you.

%d bloggers like this: